-
M3 x 6mm Screw Set – 40 pcs
$2.95Light PacketThis small hardware kit includes 20 M3 x 6mm Phillips screws and 20 M3 Nuts. -
Heat Sink Thermal Tape 35x35mm – 3M 8810
$2.95Light PacketHeat sink thermal tape is an easy way to create a strong thermal bond between an IC and a heat sink. This sheet is 35… -
Debug Cable for Raspberry Pi Pico
$2.95Light PacketThis debug cable for the Raspberry Pi Pico H is used to access the SWD (Serial Wire Debug) port. This is the tiny connector is… -
EYE SPI Cable – 50mm
$2.95Light PacketAdafruit's most recent display breakouts have come with a new feature: an 18-pin EYE SPI standard FPC connector with flip-top connector. This is intended to… -
-
12V Step-Up Voltage Regulator
$3.00Light PacketSaleBoost regulators are used to boost lower voltages to higher voltages. This tiny boost regulator (step up regulator) takes voltages of 2 - 6.0V and… -
Raspberry Pi HAT Hardware – 1/2″
$3.25Light PacketWhen using a Raspberry Pi HAT, supporting the opposite side from the header is key to preventing short circuits and damage to the HAT as… -
Raspberry Pi HAT Hardware
$3.50Light PacketWhen using a Raspberry Pi HAT, supporting the opposite side from the header is key to preventing short circuits and damage to the HAT as… -
LM386N Audio Amp
$3.50Light PacketThe LM386 is a small, low voltage, power amplifier used for audio applications. The amplifier is a single channel and will output up to 700mW… -
1/16″ Heat Shrink Tubing – 4′
$3.50Light PacketHeat shrink tubing is a must for neat wiring and cable making! This heat shrink tubing slides over your connection and shrinks down to half… -
GT2 Idler Pulley – Black – 5mm Bore
$3.50Light PacketSaleIn a toothed belt system, often a pulley is used on the opposing side of the belt to create tension to ensure the belt never…