Circuit Playground Express Educator’s Pack

$139.95

Circuit Playground Express Educator’s Pack

$139.95


Description

Circuit Playground Express is the next step towards a perfect introduction to electronics and programming. Adafruit has taken the original Circuit Playground Classic and made it even better! Not only did they pack even more sensors in, they also made it even easier to program. You can now start your journey with Microsoft MakeCode block-based or Javascript programming. Then, you can use the same board to try CircuitPython, with the Python interpreter running right on the Express. As you progress, you can advance to using Arduino IDE, which has full support of all the hardware down to the low level, so you can make powerful projects.

Because you can program the same board in 3 different ways – the Express has great value and re-usability. From beginners to experts, Circuit Playground Express has something for everyone.

The board is round and has alligator-clip pads around it so you don’t have to solder or sew to make it work. You can power it from USB, a AAA battery pack, or with a Lipoly battery (for advanced users). Circuit Playground Express has built-in USB support. Built in USB means you plug it in to program it and it just shows up, no special cable or adapter required. Just program your code into the board then take it on the go!

Included Parts:
  • 2 x Circuit Playground Express
  • 2 x USB cable – A/MicroB
  • 1 x Stainless Thin Conductive Thread – 2 ply – 23 meter/76 ft
  • 1 x Needle set – 3/9 sizes – 20 needles
  • 1 x Sewable Snaps – 5mm Diameter – Card of 24
  • 1 x Magnetic Pin Back
  • 1 x Copper Foil Tape with Conductive Adhesive – 6mm x 15 meter roll
  • 1 x Small Alligator Clip Test Lead (set of 18)
  • 3 x Alkaline AA batteries
  • 1 x AdaBot LunchBox!
  • 1 x Small Alligator Clip to Male Jumper Wire Bundle – 6 Pieces
  • 2 x Micro Servo
  • 1 x Flora RGB Smart NeoPixel version 2 – Pack of 4
  • 1 x Adafruit LED Sequins – Multicolor Pack of 5
  • 1 x JST-PH Battery Extension Cable – 500mm
  • 1 x 3x AAA Battery Holder with On/Off Switch, JST, and Belt Clip
  • 3 x Alkaline AAA batteries
  • x 3x AA Battery Holder with On/Off Switch, JST, and Belt Clip
  • 2 x Mini Storage Box

  • Features

    • Microsoft MakeCode Compatible
    • Built-in USB Support – just plug it in and program!
    • Circuit Python Compatible
    • Arduino IDE Compatible


    Resources


    Back In Stock Notification

    This item is currently out of stock, but is available for backorder. If you would like to reserve incoming stock, simply add this to your cart and checkout as per normal.

    Alternativly, if you would like to be notified when this product is back in stock, simply subscribe to the auto-notification by entering your email address below.

    Available on backorder

    Share With:
    google