16mm Panel Mount On/Off – 9-24V Red LED


16mm Panel Mount On/Off – 9-24V Red LED


SKU: BTN-039


These chrome-plated metal power buttons are rugged and look great! Simply drill a 16mm hole into any material up to 13mm / ~1/2″ thick and you can fit these in place. The button is IP65 rated and there's even a rubber gasket to keep water out of the enclosure. On the front of the button is a flat metal actuator, surrounded by a backlit plastic LED ring and inset power logo. On the back there are 3 contacts for the button (common, normally-open and normally-closed) and 2 for the backlight ring (+ and -). The contacts are compatible with our 1/8″ Quick Connects or can be directly soldered to.

This button is a single pole / dual throw (SPDT) on/off switch. When you press it the 'normally-open' contact shorts to the common contact and the button stays 'pressed'. When you press it a second time, the button springs open, and the contacts open up again. The backlight circuit is independent of the switch. Connect 9 to 24V to the LED to have it light up nicely, there's a built in resistor – no need to add one!

Need a different backlight color? These are available in Green, White, and Orange as well!


  • Drill hole diameter: 16mm
  • Switch contacts: 1 NO, 1 NC
  • Protection: IP65
  • Separate Lighting circuit
  • Switch rating: 5A
  • Material: Chrome-plated brass
  • Panel thickness: 1-13mm
  • Lamp rated voltage: 9-24V

Back In Stock Notification

This item is currently out of stock, but is available for backorder. If you would like to reserve incoming stock, simply add this to your cart and checkout as per normal.

Alternativly, if you would like to be notified when this product is back in stock, simply subscribe to the auto-notification by entering your email address below.

Available on backorder

SKU: BTN-039. Category: . Tag: .
Share With: